If you have not installed QAWeb, click here for detailed instructions on how to install QAWeb for Windows 10
Question:
- What are the recommended settings for Barco QAWeb Calibration software?
- How do I change the frequency of Barco QAWeb auto-calibration and compliance tests?
- How do I manually run a Barco QAWeb calibration and compliance test?
- Where do I find my previous calibration and compliance test reports in QAWeb?
- Barco QAWeb is not auto-calibrating and/or running the compliance test on the frequency you need
Solution:
Please follow steps below to properly install, configure and perform a full calibration and compliance test on your Barco monitors using Barco QAWeb.
Before you start, please make sure that your USB Type-B cable is connected from your monitors to your computer.
Open MediCal QAWeb Agent calibration software. You can search for the software in the search bar next to the Start Menu
Wait for QAWeb to detect the configuration
Click on Switch User
Type password: advanced then press OK
Click Status
On Auto-calibration, click Info
On Frequency, click Modify
Change Frequency to Weekly then click OK. For Mammography, select Daily
On Calibration Method, Click Modify
Select Full Calibration then click OK
Verify changes on all monitors
Click Close
On Compliance Test, click Info
On Frequency, click Modify
Change Frequency to Daily then click OK.
Verify changes on all monitors
Click Close
On Auto-Calibration, click Run
Wait for Auto-calibration to run
On the results page, take note of Action Result: OK
To view detailed report, on Detailed Result, click View Detailed Result
To save report, click Save as PDF
Click Open Report (Acrobat Reader required)
Save according to your PDF Reader Software
Following these steps for all monitors
Click Close
On Compliance Test, click Run
Wait for Compliance Test to run
On results page, take note of Action Results: OK
To view detailed report, on Detailed Result, click View Detailed Result
To save report, click Save as PDF
Click on Open Report (Acrobat Reader required)
Save according to your PDF Reader Software
Click Close
Following these steps for all monitors
Click Close
To view all reports performed on monitors, on Action History, click View the history of all actions on this workstation
To view report, under Result, click on OK or NOT OK on desired report
Conclusion:
Your monitors should now be configured with the proper settings for auto-calibration and auto-compliance testing using the Barco Medical QAWeb, DICOM Calibration and QA Software.
Comments
0 comments
Please sign in to leave a comment.